Polymaker Lsmaker

.:General Catalogue (download)

.:Datasheet (download)


Liquid dilution preparation system, fully automatic, constructed in high density polyethylene (ofering a good level of resistance in aggressive environments), allow a high quality end product to be achieved.


- The five models range from 300 to 2000 liters of capacity with concentrations of preparation according to the dosing pump applied.

- The regulation of water low and the dosing pump, with manual variator speed allows the preparation in continuous of variable concentration solutions.

- Ideal for emulsion polyelectrolyte and other liquid products solutions.

- Each system consists in a tank with two separate volumes by a lat half-moon section, constructed from high density polyethylene.

- The level switch controls the entry of water through the electrovalve in the chamber of dilution, when the minimum level of water is reached. When the maximum level is reached the level probe rises up and the electrovalve cuts the water flow. The solution is concentrated in the lower compartment and through the turmoil of the propellers, moves up to higher levels.

- The flowmeter and valve adjustment, ensure a dilution flow for the proper functioning of the preparation within the established parameters. The water and the product mix after passing through a mixer in line.

- The low-speed agitator with shaft and stainless steel propellers installed will give a total uniform solution

- The control panel has a button for overall safety and operation of individual switches with signal light and LED indicators with rend of the functioning of various elements, allowing the operator total control of the unit.