back to » mixers

FLS

.:General Catalogue (download)

.:Datasheet (download)

 

The FLS series agitators of very slow speed, provide a suction system or push the liquid depending on the position and direction of the propeller, and are ideal for various applications of occulation in water treatment plants.

They are industrial agitators with shaft, coupling and propeller type FLS of high performance built in stainless steel AISI316 L.

The FLS series has a low power consumption and allows operation to continue even dry as recommended in tanks of variable volume.

The moto-reductor (SEW) used in single phase or three-phase version, are armored, not needing any maintenance over the lifetime.

They are protected by RAL 7001 anticorrosive-paint.

 

Technical features

 

In the table shown below are the FLS models, its main characteristics and limits of application according to the geometry of the wave tank, assuming the following assumptions for their design.

- Round or square deposits with anti-vortex side walls and ratio height / diameter <1,5;

- Viscosity and density close to water;

- Propeller located at 0,4 and 0,5 times the height of liquid at the bottom;

- Viscosity and density close to water;

- Agitation liquids compatible with the material of construction (stainless steel AISI 316L).